--- (9) U-Boot 関係 ---

c) U-Boot のコマンド

U-Boot で使用するコマンドは、「help」と入力すると、簡単な説明つきの

=> help
? - alias for 'help'
base  - print or set address offset
bdinfo - print Board Info structure
boot  - boot default, i.e., run 'bootcmd'
bootd  - boot default, i.e., run 'bootcmd'
bootm  - boot application image from memory
bootp  - boot image via network using BootP/TFTP protocol
cmp   - memory compare
coninfo - print console devices and information
cp   - memory copy
crc32  - checksum calculation
dhcp  - invoke DHCP client to obtain IP/boot params
diskboot- boot from IDE device
echo  - echo args to console
erase  - erase FLASH memory
ext2load- load binary file from a Ext2 filesystem
ext2ls - list files in a directory (default /)
flinfo - print FLASH memory information
go   - start application at address 'addr'
help  - print online help
ide   - IDE sub-system
loadb  - load binary file over serial line (kermit mode)
loads  - load S-Record file over serial line
loop  - infinite loop on address range
md   - memory display
mm   - memory modify (auto-incrementing)
mtest  - simple RAM test
mw   - memory write (fill)
nfs   - boot image via network using NFS protocol
nm   - memory modify (constant address)
pci   - list and access PCI Configuration Space
ping  - send ICMP ECHO_REQUEST to network host
printenv- print environment variables
protect - enable or disable FLASH write protection
rarpboot- boot image via network using RARP/TFTP protocol
reset  - Perform RESET of the CPU
run   - run commands in an environment variable
saveenv - save environment variables to persistent storage
setenv - set environment variables
tftpboot- boot image via network using TFTP protocol
version - print monitor version

=> setenv ipaddr 192.168.XX.XX